Christmas Countdown Getting Crafty Videos

Countdown to Christmas Day 18- Easy to Make Pet Bed


Looking for a gift idea for your pet? Here’s an easy almost no-sew bed to make for your pets or to donate to a shelter or rescue.


I came up with this idea because I wanted to replace the dog beds in 3 of my dogs’ crates, but found the cheapest I could find were about $20 each. Then I came upon a pin on Pinterest which showed a variation for finishing those fleece blankets that you tie together. I really liked the look and decided I could probably make beds for a lot less than I could buy one.


Fleece- Amount depends on how big you want your bed.

Quilt batting


Hand sewing needle

Fabric scissors



1. First I folded my fabric in half so I could cut both sides at the same


2. I used my old dog bed as a pattern. If you don’t have a bed to use, make a paper pattern or you can try just measuring it out on the material. I added 1 ½ inches to each side for the part that would be cut into fringe.


3. I then cut the batting by placing the pattern on top and then cutting it. The batting is cut to the size you want your bed.


4. Once I had my pieces cut out, I began making the fringe. I found the easiest way for me was to use a fringe ruler. I used the width of the ruler as a guide for the width of each piece of fringe.


  • I began by cutting out the corners. Using a ruler I measured down each fabric edge and marking the 1 1/2 “ point with a pin. At that point I measured in from each point placing a pin along the ruler to mark where I would cut. I cut along each line to cut out the corner.
  • Once the corners were cut out, I placed the ruler so the 1 1/2” mark was at the fabric edge and the end of the ruler (the 0” end) was pointing away from me toward the center of the fabric. I then cut down the side of the ruler, stopping at the end. I repeated this down each side.
  • I adjusted the width of the fringe as I got to the end of each side if needed, to ensure they were wide enough.
  • I then cut a hole about 1/2” long into the center of each piece of fringe.


5. Once the fringe was cut, I took my piece of batting and placed it on one of the sides. I then used my needle and thread to tack the batting to the fabric in each corner and in the middle. This helps keep the batting from rolling up when the bed is washed.


6. I placed the second piece of fabric on top and began weaving the fringe.


  • Beginning with the first piece of fringe on the top of one of the sides. I pulled it through the hole in the first piece of fringe on the bottom.
  • Then I pulled the second piece of fringe on the bottom through the hole in the first piece of fringe on the top. I continued doing this around the entire bed (this is similar to how you did the edge on those pot holders you made when you were younger).
  • For the very last piece of fringe, I cut through it, so it was split into 2 pieces at the top. I inserted one piece through the hole  and tied a double knot, trimming any loose ends.


Easy to make and only took a few hours to make all three, but the big bonus was they were a hit with both the dogs and the cats!


3 replies on “Countdown to Christmas Day 18- Easy to Make Pet Bed”

Ingenious. You could even use an old egg crate mattress or memory foam if you had it.

More than likely I would sew it on the machine, but that is because my guys are tough on beds. 🙂

How much did it end up costing you?

The egg crate mattress would be a good idea. I’ll have to try one that when I make one for my Springer, Mellie.

I was lazy and didn’t feel like pulling out the sewing machine :>).

It cost me $13 for 3 yards of fabric more than enough to make 3 beds that are about 22″ x 13″. Batting about $6. I paid less to make 3 beds than it would have cost me to buy one. I was happy with that!